Step 1 - Measure the height of your opening. The post and aluminum support tube will need to be 13/32" shorter than the opening to allow for the mounting plates. Make sure that the column and support tube are cut the same length and that the cuts are square. Always double-check your length requirements before cutting.

Step 2 - The bottom end is long enough to allow for a 42" railing. You may cut 6" of the bottom end for a 36" railing. Shorten the column from the top if necessary.

Step 3 - Attach the porch column to the mounting plates as shown. Make sure that if you are using popst skirts they are slid onto the porch column before attaching the mounting plates. (Screws not provided)

Step 4 - Install porch columns by securing the mounting plates to the deck surface and roof structure. Use non-corrosive fasteners to secure the mounting plates.

Mounting Plate Diagram

Slide Royal Outdoor Products Post Skirt over the mounting plate for a completely finished look. Structural designed aluminum support tube. This special designed Composite Mounting Plate will never rust or rot. The Colonial Ccolumn can be attached directly to the surface without lifting up the roof.